Sidebar
enable_debug_mode
This is an old revision of the document!
Table of Contents
Howto enable DEBUG mode
I. Enable debug mode permanently
Simply edit both the /etc/imscp/imscp.conf and the /etc/imscp/imscp.old.conf files and set the DEBUG parameter value to 1.
II. Enable debug mode only for setup/update process
For versions already released:
Follow the procedure above and revert it back after.
For master branch:
Just run the script with the debug command line option option. (type perl <scriptname> -?) for more information about available command line options.
/var/www/virtual/i-mscp.net/wiki/htdocs/data/attic/enable_debug_mode.1355565428.txt.gz · Last modified: 2012/12/15 09:57 by nuxwin
