start:installer
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
start:installer [2016/09/25 04:10] nuxwin created |
start:installer [2016/09/25 04:21] nuxwin [Installer options] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| i-MSCP comes with an installer that allows to fully automate the installation process (or upgrade process). | i-MSCP comes with an installer that allows to fully automate the installation process (or upgrade process). | ||
| - | ====Installer mode===== | + | =====Installer modes====== |
| The i-MSCP installer can operate in two modes: | The i-MSCP installer can operate in two modes: | ||
| Line 31: | Line 31: | ||
| Once the process is finished, you must copy the file from the **/tmp/imscp** in the system root directory manually. Then, you must run the **/var/www/imscp/setup/imscp-reconfigure** script to finalize the installation. | Once the process is finished, you must copy the file from the **/tmp/imscp** in the system root directory manually. Then, you must run the **/var/www/imscp/setup/imscp-reconfigure** script to finalize the installation. | ||
| - | =====Installer options===== | + | =====Installer command line options===== |
| Run the following command to see the list of all available command line options: | Run the following command to see the list of all available command line options: | ||
/var/www/virtual/i-mscp.net/wiki/htdocs/data/pages/start/installer.txt · Last modified: 2019/02/13 10:00 by nuxwin
