User Tools

Site Tools


start:installer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
start:installer [2016/09/25 05:10]
nuxwin created
start:installer [2019/02/13 10:00]
nuxwin [Manual mode]
Line 3: Line 3:
 i-MSCP comes with an installer that allows to fully automate the installation process (or upgrade process). i-MSCP comes with an installer that allows to fully automate the installation process (or upgrade process).
  
-====Installer ​mode=====+=====Installer ​modes======
  
 The i-MSCP installer can operate in two modes: The i-MSCP installer can operate in two modes:
Line 22: Line 22:
 ====Manual mode==== ====Manual mode====
  
-In this mode, the installer will only install the required packages, and all required file will be copiued ​in a temporary directory **/​tmp/​imscp**. ​+In this mode, the installer will only install the required packages, and all required file will be copied ​in a temporary directory **/​tmp/​imscp**. ​
  
   * The prerequired packages are installed   * The prerequired packages are installed
Line 29: Line 29:
   * The build process take place: All required files are copied into a temporary directory **/​tmp/​imscp**   * The build process take place: All required files are copied into a temporary directory **/​tmp/​imscp**
  
-Once the process is finished, you must copy the file from the **/​tmp/​imscp** in the system root directory manually. Then, you must run the **/​var/​www/​imscp/​setup/​imscp-reconfigure** script to finalize the installation.+Once the process is finished, you must copy the files from the **/​tmp/​imscp** in the system root directory manually. Then, you must run the **/​var/​www/​imscp/engine/​setup/​imscp-reconfigure** script to finalize the installation. The installer will give you the needed instructions.
  
-=====Installer options=====+=====Installer ​command line options=====
  
 Run the following command to see the list of all available command line options: Run the following command to see the list of all available command line options:
/var/www/virtual/i-mscp.net/wiki/htdocs/data/pages/start/installer.txt · Last modified: 2019/02/13 10:00 by nuxwin