User Tools

Site Tools


start:installer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
start:installer [2016/09/25 04:14]
nuxwin
start:installer [2017/02/26 10:59]
gable Wrong path to reconfigure script
Line 3: Line 3:
 i-MSCP comes with an installer that allows to fully automate the installation process (or upgrade process). i-MSCP comes with an installer that allows to fully automate the installation process (or upgrade process).
  
-=====Installer ​mode======+=====Installer ​modes======
  
 The i-MSCP installer can operate in two modes: The i-MSCP installer can operate in two modes:
Line 29: Line 29:
   * The build process take place: All required files are copied into a temporary directory **/​tmp/​imscp**   * The build process take place: All required files are copied into a temporary directory **/​tmp/​imscp**
  
-Once the process is finished, you must copy the file from the **/​tmp/​imscp** in the system root directory manually. Then, you must run the **/​var/​www/​imscp/​setup/​imscp-reconfigure** script to finalize the installation.+Once the process is finished, you must copy the files from the **/​tmp/​imscp** in the system root directory manually. Then, you must run the **/​var/​www/​imscp/engine/​setup/​imscp-reconfigure** script to finalize the installation. The installer will give you the needed instructions.
  
-=====Installer options=====+=====Installer ​command line options=====
  
 Run the following command to see the list of all available command line options: Run the following command to see the list of all available command line options:
/var/www/virtual/i-mscp.net/wiki/htdocs/data/pages/start/installer.txt · Last modified: 2019/02/13 10:00 by nuxwin