User Tools

Site Tools


start:installer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
start:installer [2016/09/25 05:21]
nuxwin [Installer options]
start:installer [2019/02/13 10:00] (current)
nuxwin [Manual mode]
Line 22: Line 22:
 ====Manual mode==== ====Manual mode====
  
-In this mode, the installer will only install the required packages, and all required file will be copiued ​in a temporary directory **/​tmp/​imscp**. ​+In this mode, the installer will only install the required packages, and all required file will be copied ​in a temporary directory **/​tmp/​imscp**. ​
  
   * The prerequired packages are installed   * The prerequired packages are installed
Line 29: Line 29:
   * The build process take place: All required files are copied into a temporary directory **/​tmp/​imscp**   * The build process take place: All required files are copied into a temporary directory **/​tmp/​imscp**
  
-Once the process is finished, you must copy the file from the **/​tmp/​imscp** in the system root directory manually. Then, you must run the **/​var/​www/​imscp/​setup/​imscp-reconfigure** script to finalize the installation.+Once the process is finished, you must copy the files from the **/​tmp/​imscp** in the system root directory manually. Then, you must run the **/​var/​www/​imscp/engine/​setup/​imscp-reconfigure** script to finalize the installation. The installer will give you the needed instructions.
  
 =====Installer command line options===== =====Installer command line options=====
/var/www/virtual/i-mscp.net/wiki/htdocs/data/attic/start/installer.1474777298.txt.gz · Last modified: 2016/09/25 05:21 by nuxwin